To simplify your work, name it same as the numbers that appear in the window display on “Information of the ECU”. When the program starts reading the ECU’s chip, DO NOT INTERRUPT the process at this moment.Ĭhoose where you want to save the original file and name it. Just click on “READ” tab to assure that you will have a copy of the original file (in case there is some problem later). When the dialogue window appears just click on INFO tab and wait for the program to communicate with the ECU.Ī moment later, the information about the ECU type will be shown. If you have any doubt about the type of ECU, you can verify it from the program.
Reading the ECU EEPROM chipįirst choose the vehicle and type of the engine's ecu you want to read/write from the given list.
Click the WRITE button and select the file you want to write - Follow the instructions on screen - Switch the ignition key to “OFF” position and wait for 10 seconds before starting the engine again. Select the ECU type you want to read/write from the given list. Save the file to the Hard Disk, Edit or Forward it another folder How to WRITE data to a supported ECU: - Connect the KWP2000 PLUS ECU Flasher to computer USB port and to the diagnostic port of the car - Start the communication software in the computer. Select additional options (if needed) - Click the READ button to read out the original data (where supported). How to READ data from a supported ECU: - Connect the KWP2000 PLUS ECU Flasher to computer USB port and to the diagnostic port of the car - Start the communication software in the computer. At the window, point to the folder where you installed the driver package. Connect the KWP2000 PLUS Flasher to a free USB port. KWP 2000 PLUS ECU Flasher Driver Manual OPERATION INSTRUCTIONS: Install driver: - Install the driver package to your notebook/pc.
0 kommentar(er)
